P2495 — EGR bypass position sensor bank 1: signal too high
| Meaning | The signal from the sensor reporting the EGR cooler bypass valve position on bank 1 is above the expected value. This usually points to a broken wire or a short to supply voltage. The control unit cannot reliably read where the valve is. |
| Family | Powertrain (P) |
Typical symptoms
Engine running less smoothly in some conditions
Increased emissions or smoke
Possible power limitation
No noticeable driving symptom in some cases
Common causes
Wire shorted to supply voltage
Corroded connector
Faulty position sensor
Faulty engine control unit (rare)
What to do
How to read code P2495
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2495 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (95) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2495 mean?
EGR bypass position sensor bank 1: signal too high. The signal from the sensor reporting the EGR cooler bypass valve position on bank 1 is above the expected value. This usually points to a broken wire or a short to supply voltage. The control unit cannot reliably read where the valve is.
Can I keep driving with code P2495 active?
With caution: limp mode possible, have it checked soon
Common causes — P2495
Broken signal wire or loose connector Wire shorted to supply voltage Corroded connector Faulty position sensor Faulty engine control unit (rare)
How do you fix code P2495?
First check that the bank 1 sensor connector is fully seated and that the wires are not broken. It's best to have it checked soon so the EGR system's proper operation isn't compromised.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2494 — EGR bypass position sensor bank 1: signal too low
- Next code: P2496 — EGR bypass position sensor bank 1: erratic signal
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible