P2496 — EGR bypass position sensor bank 1: erratic signal
| Meaning | The signal from the sensor reporting the EGR cooler bypass valve position on bank 1 comes and goes or jumps irregularly. This usually points to a contact that breaks at times, such as a loose connector or a damaged wire. The fault may appear and disappear. |
| Family | Powertrain (P) |
Typical symptoms
Engine sometimes running less smoothly
Increased emissions or smoke at times
Possible intermittent power limitation
No noticeable driving symptom in some cases
Common causes
Damaged wire that breaks with vibration
Corrosion in the contacts
Position sensor working only at times
Bypass valve sticking intermittently
What to do
How to read code P2496
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2496 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (96) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2496 mean?
EGR bypass position sensor bank 1: erratic signal. The signal from the sensor reporting the EGR cooler bypass valve position on bank 1 comes and goes or jumps irregularly. This usually points to a contact that breaks at times, such as a loose connector or a damaged wire. The fault may appear and disappear.
Can I keep driving with code P2496 active?
With caution: limp mode possible, have it checked soon
Common causes — P2496
Loose connector or weak contact Damaged wire that breaks with vibration Corrosion in the contacts Position sensor working only at times Bypass valve sticking intermittently
How do you fix code P2496?
First check the connectors and gently move the bank 1 sensor wiring to see whether the signal jumps. An intermittent fault is harder to track down, so it's best to have it looked at as soon as possible.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2495 — EGR bypass position sensor bank 1: signal too high
- Next code: P2497 — EGR cooler bypass position sensor circuit bank 2:...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible