Skip to content
Fault code dictionary (DTC)

P24A6 — EGR cooler bypass stuck or open (bank 2)

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module operates the bank 2 EGR cooler bypass, the valve that decides whether recirculated exhaust gas passes through the cooler or not. It found that the valve stays stuck or open against the command. This applies to engines with two banks; the exact fault must still be verified.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Higher emissions than normal
Uneven running or loss of power
Less smooth cold starting
Slightly altered diesel consumption
Smoke from the exhaust in some conditions

Common causes

Bypass valve or actuator dirty or jammed by soot
Electric actuator or vacuum control not working
Damaged or corroded connectors or wiring
Broken or seized mechanical linkage of the valve
Internal problem in the EGR cooler
Control module not commanding the valve correctly, which is rare

What to do

It is usually not an emergency, but have it checked without too much delay because an EGR system that works badly raises emissions and fouls other parts. At the workshop the valve movement and its command should be checked before considering replacing the cooler.

How to read code P24A6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P24A6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (A6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P24A6 mean?

EGR cooler bypass stuck or open (bank 2). The control module operates the bank 2 EGR cooler bypass, the valve that decides whether recirculated exhaust gas passes through the cooler or not. It found that the valve stays stuck or open against the command. This applies to engines with two banks; the exact fault must still be verified.

Can I keep driving with code P24A6 active?

With caution: limp mode possible, have it checked soon

Common causes — P24A6

Bypass valve or actuator dirty or jammed by soot Electric actuator or vacuum control not working Damaged or corroded connectors or wiring Broken or seized mechanical linkage of the valve Internal problem in the EGR cooler Control module not commanding the valve correctly, which is rare

How do you fix code P24A6?

It is usually not an emergency, but have it checked without too much delay because an EGR system that works badly raises emissions and fouls other parts. At the workshop the valve movement and its command should be checked before considering replacing the cooler.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes