P24A9 — EGR cooler coolant pump: control circuit low
| Meaning | The control module measured too low a voltage on the wire that commands the EGR cooler coolant pump. This usually means a short to ground in the wiring or a fault in the pump or its driver. The pump may therefore not work as it should. |
| Family | Powertrain (P) |
Typical symptoms
EGR limited or disabled, with higher emissions
Pump not turning
Coolant temperature higher than normal
Loss of power in some conditions
Blown pump fuse
Common causes
Electric pump with an internal short circuit
Connector with moisture or corrosion
Faulty fuse or relay
Faulty driver inside the control module, which is rare
What to do
How to read code P24A9
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24A9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (A9) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24A9 mean?
EGR cooler coolant pump: control circuit low. The control module measured too low a voltage on the wire that commands the EGR cooler coolant pump. This usually means a short to ground in the wiring or a fault in the pump or its driver. The pump may therefore not work as it should.
Can I keep driving with code P24A9 active?
With caution: limp mode possible, have it checked soon
Common causes — P24A9
Pump wire touching ground because of worn insulation Electric pump with an internal short circuit Connector with moisture or corrosion Faulty fuse or relay Faulty driver inside the control module, which is rare
How do you fix code P24A9?
Check the wiring and connector of the pump for crushed, burnt or wet wires, and check the fuse. Do not replace the pump without measuring the circuit, because a short can damage the new one too. Have it checked soon to avoid overheating the EGR cooler.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24A8 — EGR cooler coolant pump: poor performance or stuck...
- Next code: P24AA — EGR cooler coolant pump: control circuit high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible