P24A8 — EGR cooler coolant pump: poor performance or stuck off
| Meaning | The control module commands the pump that circulates coolant through the EGR cooler, but it detected that the pump does not work as requested or stays still. The electrical circuit may be fine: the problem concerns the result, which is circulation. Without good cooling the EGR gas stays too hot. |
| Family | Powertrain (P) |
Typical symptoms
EGR limited or disabled, with higher emissions
Coolant temperature higher than normal
Loss of power in some conditions
Unusual noise from the pump or no noise at all
Slightly altered consumption
Common causes
Air in the cooling circuit
Low coolant level
Hoses or passages blocked by deposits
Insufficient electrical supply to the pump
Clogged EGR cooler
What to do
How to read code P24A8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24A8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (A8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24A8 mean?
EGR cooler coolant pump: poor performance or stuck off. The control module commands the pump that circulates coolant through the EGR cooler, but it detected that the pump does not work as requested or stays still. The electrical circuit may be fine: the problem concerns the result, which is circulation. Without good cooling the EGR gas stays too hot.
Can I keep driving with code P24A8 active?
With caution: limp mode possible, have it checked soon
Common causes — P24A8
Electric pump worn or seized Air in the cooling circuit Low coolant level Hoses or passages blocked by deposits Insufficient electrical supply to the pump Clogged EGR cooler
How do you fix code P24A8?
First check the coolant level, with the engine cold, and look for leaks. Then have a workshop verify that the pump really turns when commanded. Do not ignore the problem for long, because the EGR cooler can be damaged by heat.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24A7 — EGR cooler coolant pump: control circuit open
- Next code: P24A9 — EGR cooler coolant pump: control circuit low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible