P24B3 — Particulate matter sensor: heater control circuit open
| Meaning | The particulate matter sensor in the exhaust has an internal heater that keeps it clean and brings it to the right temperature. The control module detected that the control circuit of this heater is open, meaning interrupted. Without the heater the sensor can become fouled and give unreliable readings. |
| Family | Powertrain (P) |
Typical symptoms
No obvious change in driving
Sensor not starting up correctly
Possible limp mode on some models
Possible failure of the emissions inspection
Common causes
Heater supply wire broken
Internal heater of the sensor burnt out
Faulty supply fuse or relay
Wiring damaged by exhaust heat
Sensor control unit fault, which is rare
What to do
How to read code P24B3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B3 mean?
Particulate matter sensor: heater control circuit open. The particulate matter sensor in the exhaust has an internal heater that keeps it clean and brings it to the right temperature. The control module detected that the control circuit of this heater is open, meaning interrupted. Without the heater the sensor can become fouled and give unreliable readings.
Can I keep driving with code P24B3 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B3
Sensor connector corroded or unplugged Heater supply wire broken Internal heater of the sensor burnt out Faulty supply fuse or relay Wiring damaged by exhaust heat Sensor control unit fault, which is rare
How do you fix code P24B3?
First check the fuse, connector and wiring of the sensor, since these are the simplest checks. If they are fine, the internal heater is probably broken and the sensor needs replacing, but a workshop measurement is needed to confirm. The fault does not usually stop you driving, but it is best not to wait too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24B2 — Particulate matter sensor: intermittent circuit si...
- Next code: P24B4 — Particulate sensor heater control circuit range/pe...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible