P24B4 — Particulate sensor heater control circuit range/performance
| Meaning | The engine computer drives the heater of the particulate matter sensor, which sits in the exhaust after the particulate filter, and found that the control circuit is not behaving as expected. The heater burns soot off the sensing element. If it does not work properly, the sensor readings can become unreliable and the computer cannot monitor the filter's efficiency well. |
| Family | Powertrain (P) |
Typical symptoms
Warning message about the emissions system or particulate filter
Possible additional codes for the particulate sensor or filter
Often no noticeable change in driving
On some cars, a reduced-performance mode
Common causes
Damaged heater wiring or abnormal wiring resistance
Particulate sensor with a degraded heater
Soot or deposits on the sensing element
Internal computer fault, which is rare
What to do
How to read code P24B4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B4 mean?
Particulate sensor heater control circuit range/performance. The engine computer drives the heater of the particulate matter sensor, which sits in the exhaust after the particulate filter, and found that the control circuit is not behaving as expected. The heater burns soot off the sensing element. If it does not work properly, the sensor readings can become unreliable and the computer cannot monitor the filter's efficiency well.
Can I keep driving with code P24B4 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B4
Corroded or loose sensor connector Damaged heater wiring or abnormal wiring resistance Particulate sensor with a degraded heater Soot or deposits on the sensing element Internal computer fault, which is rare
How do you fix code P24B4?
Have the sensor data read with a diagnostic tool and have the connector and wiring checked first, as they are the most common cause. It is not an emergency, but it should not be ignored because the filter monitoring stays incomplete. Also have the condition of the particulate filter checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24B3 — Particulate matter sensor: heater control circuit...
- Next code: P24B5 — Particulate sensor heater control circuit low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible