P24B9 — EVAP leak pump pressure sensor: implausible signal
| Meaning | The engine computer is receiving a signal from the leak detection pump pressure sensor that does not match what it expects. The value is outside the normal range or does not respond as it should when the pump runs. The vapor system leak test is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Usually no change in driving
Possible fuel vapor smell
Difficult refuelling in some cases
Failed emissions inspection
Common causes
Blocked or leaking vapor system hoses
Leak detection pump working weakly
Corroded connector
Clogged filter or valves in the system
What to do
How to read code P24B9
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B9) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B9 mean?
EVAP leak pump pressure sensor: implausible signal. The engine computer is receiving a signal from the leak detection pump pressure sensor that does not match what it expects. The value is outside the normal range or does not respond as it should when the pump runs. The vapor system leak test is not reliable.
Can I keep driving with code P24B9 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B9
Faulty or out-of-calibration pressure sensor Blocked or leaking vapor system hoses Leak detection pump working weakly Corroded connector Clogged filter or valves in the system
How do you fix code P24B9?
Have the hoses, fittings and fuel cap checked, then have the sensor values read with a diagnostic tool. It is not urgent for safety, but it is best to have it checked soon so the fault does not get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24B8 — EVAP leak detection pump pressure sensor circuit
- Next code: P24BA — EVAP leak pump pressure sensor circuit low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible