P24B8 — EVAP leak detection pump pressure sensor circuit
| Meaning | The engine computer found a problem in the circuit of the pressure sensor on the pump that checks for leaks in the fuel vapor system. This pump puts the system under light pressure to check that it is sealed. If the sensor signal is not valid, the leak test cannot be carried out correctly. |
| Family | Powertrain (P) |
Typical symptoms
Usually no change in driving
Possible fuel smell around the car
Trouble refuelling, with the pump nozzle clicking off often
Failed emissions inspection
Common causes
Faulty pressure sensor
Defective leak detection pump
Cracked or disconnected vapor system hoses
Computer problem, which is rare
What to do
How to read code P24B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24B8 mean?
EVAP leak detection pump pressure sensor circuit. The engine computer found a problem in the circuit of the pressure sensor on the pump that checks for leaks in the fuel vapor system. This pump puts the system under light pressure to check that it is sealed. If the sensor signal is not valid, the leak test cannot be carried out correctly.
Can I keep driving with code P24B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P24B8
Damaged sensor connector or wiring Faulty pressure sensor Defective leak detection pump Cracked or disconnected vapor system hoses Computer problem, which is rare
How do you fix code P24B8?
First check that the fuel cap is closed properly, then have the pump connector and wiring checked. You can drive without immediate problems, but the system no longer checks for vapor leaks, so do not put it off for too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24B7 — Particulate sensor heater resistance out of range
- Next code: P24B9 — EVAP leak pump pressure sensor: implausible signal
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible