P24C0 — EVAP leak pump switching valve stuck on
| Meaning | The engine computer detected that the leak detection pump switching valve stays in its activated position even when it should return to rest. As a result the air path in the vapor system is not the intended one and the leak test gives invalid results. |
| Family | Powertrain (P) |
Typical symptoms
Usually no change in driving
Possible fuel smell
Refuelling sometimes difficult
Possible failure at the emissions inspection
Common causes
Leak detection pump with an internal defect
Electrical command stuck on because of a circuit fault
Debris or moisture in the vapor system
Computer problem, which is rare
What to do
How to read code P24C0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C0 mean?
EVAP leak pump switching valve stuck on. The engine computer detected that the leak detection pump switching valve stays in its activated position even when it should return to rest. As a result the air path in the vapor system is not the intended one and the leak test gives invalid results.
Can I keep driving with code P24C0 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C0
Valve mechanically stuck from dirt or wear Leak detection pump with an internal defect Electrical command stuck on because of a circuit fault Debris or moisture in the vapor system Computer problem, which is rare
How do you fix code P24C0?
Have the valve checked and its operation verified with the diagnostic tool, commanding it and watching the response. There is no immediate risk to driving, but the leak check is not reliable, so it is better not to wait long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24BF — EVAP leak pump switching valve control circuit hig...
- Next code: P24C1 — EVAP leak pump switching valve performance/stuck o...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible