P24C1 — EVAP leak pump switching valve performance/stuck off
| Meaning | The engine computer detected that the leak detection pump switching valve does not switch as it should, or stays in its rest position. The air path during the leak test does not change and the vapor system check is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
Usually no difference in driving
Possible fuel smell
Refuelling sometimes difficult
Possible failure at the emissions inspection
Common causes
Weak or faulty valve coil
Electrical connection with poor contact
Defective leak detection pump
Blocked passages in the vapor system
What to do
How to read code P24C1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C1 mean?
EVAP leak pump switching valve performance/stuck off. The engine computer detected that the leak detection pump switching valve does not switch as it should, or stays in its rest position. The air path during the leak test does not change and the vapor system check is not reliable.
Can I keep driving with code P24C1 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C1
Valve stuck or jammed by dirt Weak or faulty valve coil Electrical connection with poor contact Defective leak detection pump Blocked passages in the vapor system
How do you fix code P24C1?
Have the valve checked with the diagnostic tool and the connector and wiring inspected. You can drive, but the vapor system is not monitored, so have the car looked at without delaying too much.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C0 — EVAP leak pump switching valve stuck on
- Next code: P24C2 — Exhaust temperature sensors disagree, bank 1
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible