P24C3 — Exhaust temperature sensors disagree, bank 2
| Meaning | The engine computer compares the readings of the exhaust gas temperature sensors on bank 2 and found they do not agree with each other. One of the sensors may be giving wrong values, or there is a circuit problem. Exhaust temperature is used to manage the particulate filter and the catalytic converter. |
| Family | Powertrain (P) |
Typical symptoms
Warning message about the emissions system
Abnormal or more frequent particulate filter regeneration
Possible power limitation
Other codes for exhaust temperature sensors
Common causes
Damaged connector or wiring on one sensor
Exhaust leak near a sensor
Sensor badly fitted or coated in deposits
Filter or catalytic converter problem altering temperatures
What to do
How to read code P24C3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C3 mean?
Exhaust temperature sensors disagree, bank 2. The engine computer compares the readings of the exhaust gas temperature sensors on bank 2 and found they do not agree with each other. One of the sensors may be giving wrong values, or there is a circuit problem. Exhaust temperature is used to manage the particulate filter and the catalytic converter.
Can I keep driving with code P24C3 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C3
Faulty or out-of-calibration exhaust temperature sensor Damaged connector or wiring on one sensor Exhaust leak near a sensor Sensor badly fitted or coated in deposits Filter or catalytic converter problem altering temperatures
How do you fix code P24C3?
Have the temperatures of all bank 2 sensors read with the diagnostic tool to see which one is off, and have connectors and wiring checked. If a power limitation appears, do not delay too much. Bank 2 is the side opposite the one with cylinder 1, and exists only on V or flat engines.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C2 — Exhaust temperature sensors disagree, bank 1
- Next code: P24C4 — EGR cooler bypass position sensor exceeded learnin...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible