P24C4 — EGR cooler bypass position sensor exceeded learning limit, bank 1
| Meaning | The engine computer learns over time the reference position of the EGR cooler bypass valve sensor, which routes recirculated exhaust gas through the cooler or around it. The learned value on bank 1 has gone beyond the allowed limit. This usually points to wear, deposits or a fault in the sensor or actuator. |
| Family | Powertrain (P) |
Typical symptoms
Possible loss of power or rough running
Higher than normal emissions
Other codes for the EGR system
Often no obvious symptoms
Common causes
Worn or out-of-calibration position sensor
Weak bypass valve actuator
Mechanically stiff linkage or valve
Connector or wiring with a poor contact
What to do
How to read code P24C4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C4 mean?
EGR cooler bypass position sensor exceeded learning limit, bank 1. The engine computer learns over time the reference position of the EGR cooler bypass valve sensor, which routes recirculated exhaust gas through the cooler or around it. The learned value on bank 1 has gone beyond the allowed limit. This usually points to wear, deposits or a fault in the sensor or actuator.
Can I keep driving with code P24C4 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C4
Soot deposits blocking or slowing the bypass valve Worn or out-of-calibration position sensor Weak bypass valve actuator Mechanically stiff linkage or valve Connector or wiring with a poor contact
How do you fix code P24C4?
Have the bypass valve and its sensor checked, verifying whether it moves freely and whether the position it reads is correct. It is not an emergency but it is a wear sign not to ignore, especially if power loss or other EGR codes appear. After the repair the computer may need to learn the position again.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C3 — Exhaust temperature sensors disagree, bank 2
- Next code: P24C5 — EGR cooler bypass position sensor exceeded learnin...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible