P24C6 — Particulate matter sensor temperature circuit
| Meaning | The engine computer found a problem in the circuit that measures the temperature of the particulate matter sensor, located in the exhaust after the filter. This temperature is used to run the sensor and its heater under the right conditions. If the signal is not valid, the particle reading may be unreliable. |
| Family | Powertrain (P) |
Typical symptoms
Warning message about the emissions system
Possible other codes for the particulate sensor
Usually no change in driving
Possible power limitation on some models
Common causes
Faulty temperature measuring element in the sensor
Sensor damaged by heat or moisture
Corroded terminals in the connector
Computer problem, which is rare
What to do
How to read code P24C6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C6 mean?
Particulate matter sensor temperature circuit. The engine computer found a problem in the circuit that measures the temperature of the particulate matter sensor, located in the exhaust after the filter. This temperature is used to run the sensor and its heater under the right conditions. If the signal is not valid, the particle reading may be unreliable.
Can I keep driving with code P24C6 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C6
Damaged sensor connector or wiring Faulty temperature measuring element in the sensor Sensor damaged by heat or moisture Corroded terminals in the connector Computer problem, which is rare
How do you fix code P24C6?
Have the particulate sensor connector and wiring checked and the temperature values read with the diagnostic tool. It is not a fault that requires stopping at once, but do not delay for long, because the filter monitoring stays incomplete. If the sensor is faulty, it needs replacing.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C5 — EGR cooler bypass position sensor exceeded learnin...
- Next code: P24C7 — Particulate sensor temperature circuit range/perfo...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible