P24C7 — Particulate sensor temperature circuit range/performance
| Meaning | The engine computer found that the temperature measured by the particulate matter sensor does not match what it expects under the current driving conditions. The signal is present but not plausible: it may be slow, stuck or out of range. In that case the sensor may not be working at the correct temperature. |
| Family | Powertrain (P) |
Typical symptoms
Warning message about the emissions system
Possible other codes for the particulate sensor or filter
Usually no difference in driving
Possible power limitation on some cars
Common causes
Connector with a poor contact
Soot deposits or dirt on the sensor
Exhaust leak altering temperatures
Particulate filter problem changing the gas flow
What to do
How to read code P24C7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C7 mean?
Particulate sensor temperature circuit range/performance. The engine computer found that the temperature measured by the particulate matter sensor does not match what it expects under the current driving conditions. The signal is present but not plausible: it may be slow, stuck or out of range. In that case the sensor may not be working at the correct temperature.
Can I keep driving with code P24C7 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C7
Particulate sensor with an out-of-calibration temperature measurement Connector with a poor contact Soot deposits or dirt on the sensor Exhaust leak altering temperatures Particulate filter problem changing the gas flow
How do you fix code P24C7?
Have the sensor data read with the diagnostic tool, comparing its temperature with that of the other exhaust sensors, and have the connector and exhaust sealing checked. You do not need to stop at once, but have it checked with some promptness.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C6 — Particulate matter sensor temperature circuit
- Next code: P24C8 — Particulate sensor temperature circuit signal too...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible