P24CA — Particulate sensor temperature circuit signal intermittent
| Meaning | The control unit sees the temperature signal from the particulate matter sensor coming and going. The fault only shows up from time to time, usually because an electrical contact breaks under vibration, heat or moisture. That is why it can disappear and come back without a clear pattern. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system fault message that comes and goes
Irregular filter regenerations
No clear driving symptoms
Problem appearing after washing, rain or rough roads
Common causes
Partly broken or chafed wire
Water getting into the connector
Particulate matter sensor starting to fail
Ground or power problem in the wiring (less common)
What to do
How to read code P24CA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24CA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (CA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24CA mean?
Particulate sensor temperature circuit signal intermittent. The control unit sees the temperature signal from the particulate matter sensor coming and going. The fault only shows up from time to time, usually because an electrical contact breaks under vibration, heat or moisture. That is why it can disappear and come back without a clear pattern.
Can I keep driving with code P24CA active?
With caution: limp mode possible, have it checked soon
Common causes — P24CA
Loose or corroded sensor connector Partly broken or chafed wire Water getting into the connector Particulate matter sensor starting to fail Ground or power problem in the wiring (less common)
How do you fix code P24CA?
Check the sensor connector and wiring, gently moving the wires with the engine off and cold to look for unstable contacts. It is not an emergency, but an intermittent fault tends to get worse, so don't leave it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C9 — Particulate sensor temperature circuit signal too...
- Next code: P24CB — AdBlue tank cap switch circuit fault
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible