P24C9 — Particulate sensor temperature circuit signal too high
| Meaning | The control unit detected a higher voltage than normal in the circuit that reads the temperature of the particulate matter sensor. In practice the signal wire may be open, a wire may be touching a power supply, or the sensor itself is faulty. The reading cannot be trusted, which affects how the filter is monitored. |
| Family | Powertrain (P) |
Typical symptoms
Warning light or message related to the particulate filter
Abnormal or too frequent filter regenerations
Possible power reduction on some models
Often no change in how the car drives
Common causes
Corroded connector or terminals pushed back
Wire touching a power supply because of damaged insulation
Failed particulate matter sensor
Faulty control unit (rare)
What to do
How to read code P24C9
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24C9 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (C9) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24C9 mean?
Particulate sensor temperature circuit signal too high. The control unit detected a higher voltage than normal in the circuit that reads the temperature of the particulate matter sensor. In practice the signal wire may be open, a wire may be touching a power supply, or the sensor itself is faulty. The reading cannot be trusted, which affects how the filter is monitored.
Can I keep driving with code P24C9 active?
With caution: limp mode possible, have it checked soon
Common causes — P24C9
Broken sensor wire or loose contact Corroded connector or terminals pushed back Wire touching a power supply because of damaged insulation Failed particulate matter sensor Faulty control unit (rare)
How do you fix code P24C9?
First check the connector and wiring of the sensor in the exhaust, looking for broken or burnt wires and moisture. You can carry on carefully, but have it checked soon, because the filter is not being monitored well.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24C8 — Particulate sensor temperature circuit signal too...
- Next code: P24CA — Particulate sensor temperature circuit signal inte...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible