P24D2 — AdBlue heater A sense circuit fault
| Meaning | The control unit found a problem in the circuit that monitors heater A of the AdBlue system (the urea-based fluid that freezes in the cold). The code says the monitoring signal is not correct, but it does not say which part is broken. The heater keeps the fluid usable in cold weather. |
| Family | Powertrain (P) |
Typical symptoms
AdBlue system fault message
More noticeable problems at low temperatures
Possible restart restrictions if the fault is not resolved
No noticeable driving change in many cases
Common causes
Faulty heater in the tank or line
Relay or fuse problem for the heater
Faulty current or temperature sensing in the circuit
Faulty AdBlue control module (less common)
What to do
How to read code P24D2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24D2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24D2 mean?
AdBlue heater A sense circuit fault. The control unit found a problem in the circuit that monitors heater A of the AdBlue system (the urea-based fluid that freezes in the cold). The code says the monitoring signal is not correct, but it does not say which part is broken. The heater keeps the fluid usable in cold weather.
Can I keep driving with code P24D2 active?
With caution: limp mode possible, have it checked soon
Common causes — P24D2
Damaged heater wiring or connector Faulty heater in the tank or line Relay or fuse problem for the heater Faulty current or temperature sensing in the circuit Faulty AdBlue control module (less common)
How do you fix code P24D2?
Have the fuse, connector and wiring of the heater checked first, then the heater itself. The fault matters more in cold weather, so it is best dealt with before winter. For the exact meaning of heater circuits A and B, the manufacturer's data should be consulted.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24D1 — Particulate sensor self-cleaning cycle incomplete
- Next code: P24D3 — AdBlue heater B sense circuit fault
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible