P24D3 — AdBlue heater B sense circuit fault
| Meaning | The control unit found a problem in the circuit that monitors heater B of the AdBlue system. The signal is not correct, but the code alone does not say which component is faulty. Which part of the system is heater B depends on the car model. |
| Family | Powertrain (P) |
Typical symptoms
AdBlue system fault message
More difficulty in cold weather
Possible restart restrictions if the fault remains
Often no noticeable driving change
Common causes
Faulty heater (tank, pump or line, depending on the car)
Fuse or relay problem
Faulty sensing circuit or sensor
Faulty AdBlue control module (less common)
What to do
How to read code P24D3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24D3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (D3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24D3 mean?
AdBlue heater B sense circuit fault. The control unit found a problem in the circuit that monitors heater B of the AdBlue system. The signal is not correct, but the code alone does not say which component is faulty. Which part of the system is heater B depends on the car model.
Can I keep driving with code P24D3 active?
With caution: limp mode possible, have it checked soon
Common causes — P24D3
Damaged heater wiring or connector Faulty heater (tank, pump or line, depending on the car) Fuse or relay problem Faulty sensing circuit or sensor Faulty AdBlue control module (less common)
How do you fix code P24D3?
Have the fuses, connector and wiring of the heater checked, then the heater itself. To know which part heater B refers to, you need the data specific to your car. It is better not to wait for cold weather to fix it.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24D2 — AdBlue heater A sense circuit fault
- Next code: P24D4 — EGR cooler coolant pump feedback circuit fault
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible