P24E0 — Reductant purge control valve B stuck closed
| Meaning | The control module has determined that purge valve B of the reductant system (the AdBlue used by the SCR system) stays closed when it should open. The system therefore cannot drain or purge as intended. Which valve is called B and exactly what it does depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
SCR fault message on the dashboard
Possible power limitation
Unusual noise or pressure from the AdBlue pump
Possible starting difficulty after a period of SCR lockout
Common causes
Blocked or frozen line
Faulty coil or mechanical part of the valve
Electrical problem preventing the open command
Fault in the control unit or dosing module
What to do
How to read code P24E0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E0 mean?
Reductant purge control valve B stuck closed. The control module has determined that purge valve B of the reductant system (the AdBlue used by the SCR system) stays closed when it should open. The system therefore cannot drain or purge as intended. Which valve is called B and exactly what it does depends on the manufacturer.
Can I keep driving with code P24E0 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E0
Valve stuck by urea crystals Blocked or frozen line Faulty coil or mechanical part of the valve Electrical problem preventing the open command Fault in the control unit or dosing module
How do you fix code P24E0?
Check that the AdBlue lines are not blocked or frozen and that the valve has no deposits. Don't neglect it: on many vehicles a persistent SCR fault leads to power limitation.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24DF — Reductant purge control valve B stuck open
- Next code: P24E1 — NH3 sensor circuit fault
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible