P24E1 — NH3 sensor circuit fault
| Meaning | The control module has found an electrical problem in the NH3 sensor circuit. This is the ammonia sensor placed in the exhaust after the SCR catalyst, used to check that AdBlue is dosed in the right amount. Without a reliable signal the control module cannot manage the system properly. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
Inaccurate AdBlue dosing
Higher than normal emissions, not noticeable while driving
Common causes
Damaged wiring or wiring touching hot parts
Faulty NH3 sensor
Sensor power supply or ground problem
Control unit fault
What to do
How to read code P24E1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E1 mean?
NH3 sensor circuit fault. The control module has found an electrical problem in the NH3 sensor circuit. This is the ammonia sensor placed in the exhaust after the SCR catalyst, used to check that AdBlue is dosed in the right amount. Without a reliable signal the control module cannot manage the system properly.
Can I keep driving with code P24E1 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E1
Corroded or loose sensor connector Damaged wiring or wiring touching hot parts Faulty NH3 sensor Sensor power supply or ground problem Control unit fault
How do you fix code P24E1?
Check the sensor connector and wiring, which are exposed to heat and moisture. Have the fault checked within a reasonable time, because an SCR system without control can trigger manufacturer restrictions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24E0 — Reductant purge control valve B stuck closed
- Next code: P24E2 — NH3 sensor range or performance problem
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible