P24E3 — NH3 sensor circuit low signal
| Meaning | The control module reads a value that is too low on the NH3 sensor circuit (the ammonia sensor after the SCR catalyst), compared with the expected range. This usually points to a short to ground, a damaged wire or a faulty sensor. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
Inaccurate AdBlue dosing
No obvious driving symptoms apart from the warning lights
Common causes
Wet or corroded connector
Faulty NH3 sensor
Insufficient sensor power supply
Control unit fault
What to do
How to read code P24E3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E3 mean?
NH3 sensor circuit low signal. The control module reads a value that is too low on the NH3 sensor circuit (the ammonia sensor after the SCR catalyst), compared with the expected range. This usually points to a short to ground, a damaged wire or a faulty sensor.
Can I keep driving with code P24E3 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E3
Sensor wire shorted to ground Wet or corroded connector Faulty NH3 sensor Insufficient sensor power supply Control unit fault
How do you fix code P24E3?
Check the sensor wiring and connector for moisture, corrosion or rubbing marks. Don't leave the fault too long, because it can lead to SCR system restrictions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24E2 — NH3 sensor range or performance problem
- Next code: P24E4 — NH3 sensor circuit high signal
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible