P24E2 — NH3 sensor range or performance problem
| Meaning | The control module receives from the NH3 sensor (the ammonia sensor after the SCR catalyst) a signal that does not match what it expects, even though the electrical circuit may be fine. The sensor could be slow, dirty or aged, or the AdBlue dosing could really be wrong. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
Unusual AdBlue consumption
Higher than normal emissions, not noticeable while driving
Common causes
Wrong AdBlue dosing from a dirty injector or weak pump
Degraded SCR catalyst
Exhaust leaks near the sensor
Poor quality or diluted AdBlue
Wiring or connector with abnormal resistance
What to do
How to read code P24E2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E2 mean?
NH3 sensor range or performance problem. The control module receives from the NH3 sensor (the ammonia sensor after the SCR catalyst) a signal that does not match what it expects, even though the electrical circuit may be fine. The sensor could be slow, dirty or aged, or the AdBlue dosing could really be wrong.
Can I keep driving with code P24E2 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E2
Aged or contaminated NH3 sensor Wrong AdBlue dosing from a dirty injector or weak pump Degraded SCR catalyst Exhaust leaks near the sensor Poor quality or diluted AdBlue Wiring or connector with abnormal resistance
How do you fix code P24E2?
Before replacing the sensor, have the AdBlue dosing, the fluid quality and any exhaust leaks checked. Act reasonably promptly, because the fault concerns emissions control.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact usRelated codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible