P24E5 — NH3 sensor circuit intermittent or erratic
| Meaning | The control module sees the signal from the NH3 sensor (the ammonia sensor after the SCR catalyst) appear and disappear, or vary irregularly. The fault shows up on and off, often because of a contact that opens and closes with vibration, heat or moisture. |
| Family | Powertrain (P) |
Typical symptoms
Intermittent SCR fault message
Possible power limitation at times
Irregular AdBlue dosing
No obvious driving symptoms
Common causes
Wiring with a partly broken wire
Moisture or corrosion in the connector
NH3 sensor starting to fail
Power supply or ground dropping out at times
What to do
How to read code P24E5
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E5) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E5 mean?
NH3 sensor circuit intermittent or erratic. The control module sees the signal from the NH3 sensor (the ammonia sensor after the SCR catalyst) appear and disappear, or vary irregularly. The fault shows up on and off, often because of a contact that opens and closes with vibration, heat or moisture.
Can I keep driving with code P24E5 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E5
Sensor connector with an unstable contact Wiring with a partly broken wire Moisture or corrosion in the connector NH3 sensor starting to fail Power supply or ground dropping out at times
How do you fix code P24E5?
With the engine off you can carefully move the wiring and connector to look for an unstable contact, but it is better to have a workshop do it with live data. An intermittent fault tends to get worse, so it is not wise to postpone it for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24E4 — NH3 sensor circuit high signal
- Next code: P24E6 — NH3 sensor heater circuit open
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible