P24E6 — NH3 sensor heater circuit open
| Meaning | The control module has detected that the heater circuit of the NH3 sensor (the ammonia sensor after the SCR catalyst) is open or has no continuity. The sensor needs to be heated to measure correctly, so without the heater its signal is not reliable. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
NH3 sensor slow to start working
No obvious driving symptoms apart from the warning lights
Common causes
Loose or corroded connector
Broken heater wire
Faulty fuse or power relay
Fault in the control unit that drives the heater
What to do
How to read code P24E6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E6 mean?
NH3 sensor heater circuit open. The control module has detected that the heater circuit of the NH3 sensor (the ammonia sensor after the SCR catalyst) is open or has no continuity. The sensor needs to be heated to measure correctly, so without the heater its signal is not reliable.
Can I keep driving with code P24E6 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E6
Heater element inside the sensor broken Loose or corroded connector Broken heater wire Faulty fuse or power relay Fault in the control unit that drives the heater
How do you fix code P24E6?
Check the sensor connector and wiring, then check the fuse and power supply of the heater. Have it dealt with within a reasonable time, because without the sensor the SCR system is not properly controlled.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24E5 — NH3 sensor circuit intermittent or erratic
- Next code: P24E7 — NH3 sensor heater circuit low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible