P24E8 — NH3 sensor heater circuit high
| Meaning | The control module measures a voltage that is too high on the heater circuit of the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to the power supply, a faulty contact or a ground problem. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
NH3 sensor not heating correctly
No obvious driving symptoms apart from the warning lights
Common causes
Heater ground broken or corroded
Loose or damaged connector
Faulty heater inside the sensor
Fault in the control unit that drives it
What to do
How to read code P24E8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E8 mean?
NH3 sensor heater circuit high. The control module measures a voltage that is too high on the heater circuit of the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to the power supply, a faulty contact or a ground problem.
Can I keep driving with code P24E8 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E8
Heater wire shorted to the power supply Heater ground broken or corroded Loose or damaged connector Faulty heater inside the sensor Fault in the control unit that drives it
How do you fix code P24E8?
Check that the connector and wiring are intact and that the sensor ground is in good condition. Have the fault checked within a reasonable time, because it can lead to SCR system restrictions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24E7 — NH3 sensor heater circuit low
- Next code: P24E9 — NH3 sensor heater performance problem
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible