P24E7 — NH3 sensor heater circuit low
| Meaning | The control module measures a voltage that is too low on the heater circuit of the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to ground in the wiring or in the heater itself. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
NH3 sensor not reaching its working temperature
No obvious driving symptoms apart from the warning lights
Common causes
Wet or corroded connector
Heater inside the sensor shorted
Fuse or power supply problem
Control unit fault
What to do
How to read code P24E7
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24E7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (E7) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24E7 mean?
NH3 sensor heater circuit low. The control module measures a voltage that is too low on the heater circuit of the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to ground in the wiring or in the heater itself.
Can I keep driving with code P24E7 active?
With caution: limp mode possible, have it checked soon
Common causes — P24E7
Heater wire shorted to ground Wet or corroded connector Heater inside the sensor shorted Fuse or power supply problem Control unit fault
How do you fix code P24E7?
Check the sensor wiring and connector, looking for rubbed wires or moisture. Have the fault checked without leaving it too long, because it affects emissions control.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24E6 — NH3 sensor heater circuit open
- Next code: P24E8 — NH3 sensor heater circuit high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible