P24EA — NH3 sensor supply voltage circuit fault
| Meaning | The control module has detected a problem with the supply voltage of the NH3 sensor (the ammonia sensor after the SCR catalyst). Without a correct supply the sensor cannot give a reliable signal. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
Inaccurate AdBlue dosing
No obvious driving symptoms apart from the warning lights
Common causes
Damaged supply wiring
Faulty fuse or relay
Faulty NH3 sensor drawing abnormal current
Fault in the control unit or module that powers the sensor
What to do
How to read code P24EA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24EA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (EA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24EA mean?
NH3 sensor supply voltage circuit fault. The control module has detected a problem with the supply voltage of the NH3 sensor (the ammonia sensor after the SCR catalyst). Without a correct supply the sensor cannot give a reliable signal.
Can I keep driving with code P24EA active?
With caution: limp mode possible, have it checked soon
Common causes — P24EA
Corroded or loose sensor connector Damaged supply wiring Faulty fuse or relay Faulty NH3 sensor drawing abnormal current Fault in the control unit or module that powers the sensor
How do you fix code P24EA?
Check the connector, wiring and fuses of the sensor supply. Have the fault checked within a reasonable time, because without a correct supply the SCR is not properly controlled.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24E9 — NH3 sensor heater performance problem
- Next code: P24EB — NH3 sensor supply voltage low
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible