P24EB — NH3 sensor supply voltage low
| Meaning | The control module measures a supply voltage that is too low at the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to ground, a poor contact or a sensor drawing too much current. |
| Family | Powertrain (P) |
Typical symptoms
SCR system fault message
Possible power limitation
NH3 sensor signal missing or wrong
No obvious driving symptoms apart from the warning lights
Common causes
Wet or corroded connector
Internal short in the NH3 sensor
Fuse or power supply problem
Control unit fault
What to do
How to read code P24EB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24EB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (EB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24EB mean?
NH3 sensor supply voltage low. The control module measures a supply voltage that is too low at the NH3 sensor (the ammonia sensor after the SCR catalyst). This usually points to a short to ground, a poor contact or a sensor drawing too much current.
Can I keep driving with code P24EB active?
With caution: limp mode possible, have it checked soon
Common causes — P24EB
Supply wire shorted to ground Wet or corroded connector Internal short in the NH3 sensor Fuse or power supply problem Control unit fault
How do you fix code P24EB?
Check the sensor connector and wiring, looking for moisture or rubbed wires. Have the fault checked without leaving it too long, to avoid SCR system restrictions.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24EA — NH3 sensor supply voltage circuit fault
- Next code: P24EC — NH3 sensor supply voltage high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible