P24F4 — Upstream NOx sensor slow to respond from high to low, bank 1
| Meaning | The NOx (nitrogen oxides) sensor fitted ahead of the SCR catalyst on bank 1 takes too long to register the drop when NOx values go from high to low. The control module considers the sensor too slow and can no longer trust its readings. That data is used to dose the AdBlue correctly. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system or AdBlue warning message
Unusual AdBlue consumption
Possible power limitation on some vehicles
No obvious change in how the car drives
Common causes
Exhaust leak near the sensor
Damaged wiring or connector at the sensor
Rough combustion fouling the sensor
Fault in the NOx sensor's own control unit
What to do
How to read code P24F4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24F4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24F4 mean?
Upstream NOx sensor slow to respond from high to low, bank 1. The NOx (nitrogen oxides) sensor fitted ahead of the SCR catalyst on bank 1 takes too long to register the drop when NOx values go from high to low. The control module considers the sensor too slow and can no longer trust its readings. That data is used to dose the AdBlue correctly.
Can I keep driving with code P24F4 active?
With caution: limp mode possible, have it checked soon
Common causes — P24F4
Aged or contaminated NOx sensor Exhaust leak near the sensor Damaged wiring or connector at the sensor Rough combustion fouling the sensor Fault in the NOx sensor's own control unit
How do you fix code P24F4?
Check there are no exhaust leaks ahead of the sensor and that the connector and wiring are intact. Then have the sensor checked on a scan tool, watching live values. Don't leave the fault for too long, because the SCR system can go into protection mode.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24F3 — Reductant tank temperature and fuel temperature do...
- Next code: P24F5 — Downstream NOx sensor slow to respond from high to...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible