P24F3 — Reductant tank temperature and fuel temperature do not match
| Meaning | The control module compares the temperature of the reductant tank (the AdBlue or diesel exhaust fluid used by the SCR system) with the fuel temperature. After a long rest the two should be similar, and if they aren't, one of the sensors is probably reading wrongly. The SCR system uses this data to manage heating and dosing. |
| Family | Powertrain (P) |
Typical symptoms
Emissions system fault message
Reduced or suspended AdBlue dosing
Tank heating not behaving properly in winter
No obvious driving symptoms at first
Common causes
Faulty fuel temperature sensor
Damaged wiring or connector at the sensors
Tank module with a faulty heater or sensor
Problem in the control module or its software
What to do
How to read code P24F3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24F3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24F3 mean?
Reductant tank temperature and fuel temperature do not match. The control module compares the temperature of the reductant tank (the AdBlue or diesel exhaust fluid used by the SCR system) with the fuel temperature. After a long rest the two should be similar, and if they aren't, one of the sensors is probably reading wrongly. The SCR system uses this data to manage heating and dosing.
Can I keep driving with code P24F3 active?
With caution: limp mode possible, have it checked soon
Common causes — P24F3
Faulty temperature sensor in the AdBlue tank Faulty fuel temperature sensor Damaged wiring or connector at the sensors Tank module with a faulty heater or sensor Problem in the control module or its software
How do you fix code P24F3?
Have the two temperatures read after the car has sat overnight: they should be close. If one is off, check that sensor and its wiring. Don't ignore it for long, because on many vehicles the SCR system can restrict starting if the problem stays.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24F2 — EGR temperature and charge air temperature do not...
- Next code: P24F4 — Upstream NOx sensor slow to respond from high to l...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible