P24F6 — Exhaust fuel injection air purge valve stuck open
| Meaning | This code concerns the valve that sends air to clean the system that injects fuel into the exhaust (used to heat or regenerate the filter). The control module sees the valve staying open when it should be closed. Only some manufacturers use this system, and I don't have reliable details of how it is built on every make. |
| Family | Powertrain (P) |
Typical symptoms
Particulate filter regeneration not completing
More smoke or a fuel smell from the exhaust
Unusual exhaust temperatures
Possible loss of power
Common causes
Broken spring or internal mechanism
Soot or carbon deposits in the valve
Air lines in poor condition
Electrical fault keeping the valve energised
What to do
How to read code P24F6
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24F6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F6) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24F6 mean?
Exhaust fuel injection air purge valve stuck open. This code concerns the valve that sends air to clean the system that injects fuel into the exhaust (used to heat or regenerate the filter). The control module sees the valve staying open when it should be closed. Only some manufacturers use this system, and I don't have reliable details of how it is built on every make.
Can I keep driving with code P24F6 active?
With caution: limp mode possible, have it checked soon
Common causes — P24F6
Valve dirty or stuck in the open position Broken spring or internal mechanism Soot or carbon deposits in the valve Air lines in poor condition Electrical fault keeping the valve energised
How do you fix code P24F6?
Have the valve and its connecting lines checked, and verify on a scan tool whether it responds to commands. Don't keep driving for long with the light on if you smell fuel from the exhaust: get the car looked at soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24F5 — Downstream NOx sensor slow to respond from high to...
- Next code: P24F7 — Exhaust fuel injection air purge valve stuck close...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible