Skip to content
Fault code dictionary (DTC)

P24F7 — Exhaust fuel injection air purge valve stuck closed

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThis code concerns the valve that sends air to clean the system that injects fuel into the exhaust. The control module sees the valve staying closed when it should open. Without the purge, the injector in the exhaust can get dirty or clogged. Only a few manufacturers use this system, and I don't have reliable details of how it is built on every make.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Particulate filter regeneration not starting or not completing
Filter clogging up faster
Possible loss of power
Emissions fault message

Common causes

Valve stuck or dirty in the closed position
Air line blocked or pinched
Broken internal mechanism in the valve
Soot or carbon deposits
No power or command reaching the valve

What to do

Have a scan tool check whether the valve opens when commanded, and inspect the air lines. It's best not to put it off, because a dirty injector or a clogged filter gets worse with use.

How to read code P24F7

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P24F7 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F7) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P24F7 mean?

Exhaust fuel injection air purge valve stuck closed. This code concerns the valve that sends air to clean the system that injects fuel into the exhaust. The control module sees the valve staying closed when it should open. Without the purge, the injector in the exhaust can get dirty or clogged. Only a few manufacturers use this system, and I don't have reliable details of how it is built on every make.

Can I keep driving with code P24F7 active?

With caution: limp mode possible, have it checked soon

Common causes — P24F7

Valve stuck or dirty in the closed position Air line blocked or pinched Broken internal mechanism in the valve Soot or carbon deposits No power or command reaching the valve

How do you fix code P24F7?

Have a scan tool check whether the valve opens when commanded, and inspect the air lines. It's best not to put it off, because a dirty injector or a clogged filter gets worse with use.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes