Skip to content
Fault code dictionary (DTC)

P24F8 — Exhaust fuel injection air purge valve control circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module found a general problem in the electrical circuit that drives the air purge valve of the system that injects fuel into the exhaust. The code doesn't say whether the fault is in the wiring, the valve or the module: more tests are needed. Only a few manufacturers use this system, and I don't have reliable details of its layout on every make.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Unusual particulate filter regeneration
Loss of power
Emissions fault message
No obvious symptom in mild cases

Common causes

Valve wiring broken or shorted
Corroded or loose connector
Faulty solenoid coil
Blown fuse or missing power supply
Driver fault inside the control module

What to do

Have the valve's connector and wiring checked and the solenoid resistance measured. Then verify the power and ground of the control circuit. Don't ignore it for long, because it can interfere with filter regeneration.

How to read code P24F8

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P24F8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (F8) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P24F8 mean?

Exhaust fuel injection air purge valve control circuit fault. The control module found a general problem in the electrical circuit that drives the air purge valve of the system that injects fuel into the exhaust. The code doesn't say whether the fault is in the wiring, the valve or the module: more tests are needed. Only a few manufacturers use this system, and I don't have reliable details of its layout on every make.

Can I keep driving with code P24F8 active?

With caution: limp mode possible, have it checked soon

Common causes — P24F8

Valve wiring broken or shorted Corroded or loose connector Faulty solenoid coil Blown fuse or missing power supply Driver fault inside the control module

How do you fix code P24F8?

Have the valve's connector and wiring checked and the solenoid resistance measured. Then verify the power and ground of the control circuit. Don't ignore it for long, because it can interfere with filter regeneration.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes