P24FA — Exhaust air purge valve control circuit low
| Meaning | The control module found that the control circuit of the air purge valve is at a lower voltage than expected, typically from a wire shorted to ground or a missing supply. The valve isn't being driven correctly. Only a few manufacturers use this system, and I don't have reliable details on every make. |
| Family | Powertrain (P) |
Typical symptoms
Particulate filter regeneration not working well
Loss of power
Emissions fault message
Possible fuel smell from the exhaust
Common causes
Wiring crushed or chafed
Corroded or wet connector
Solenoid with a shorted coil
Driver fault inside the control module
What to do
How to read code P24FA
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24FA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (FA) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24FA mean?
Exhaust air purge valve control circuit low. The control module found that the control circuit of the air purge valve is at a lower voltage than expected, typically from a wire shorted to ground or a missing supply. The valve isn't being driven correctly. Only a few manufacturers use this system, and I don't have reliable details on every make.
Can I keep driving with code P24FA active?
With caution: limp mode possible, have it checked soon
Common causes — P24FA
Control wire shorted to ground Wiring crushed or chafed Corroded or wet connector Solenoid with a shorted coil Driver fault inside the control module
How do you fix code P24FA?
Have the valve's wiring checked along its route, especially where it runs near hot or moving parts. Then check the coil resistance. Don't put it off too long, because a short can also damage the control module.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24F9 — Exhaust air purge valve control circuit performanc...
- Next code: P24FB — Exhaust air purge valve control circuit high
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible