P24FB — Exhaust air purge valve control circuit high
| Meaning | The control module found that the control circuit of the air purge valve is at a higher voltage than expected, typically from a wire shorted to the supply or from an open circuit. The valve isn't being driven correctly. Only a few manufacturers use this system, and I don't have reliable details on every make. |
| Family | Powertrain (P) |
Typical symptoms
Unusual particulate filter regeneration
Loss of power
Emissions fault message
No obvious symptom in mild cases
Common causes
Open circuit from a broken wire
Loose or corroded connector
Solenoid with an open coil
Driver fault inside the control module
What to do
How to read code P24FB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P24FB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (4) points to auxiliary emission controls, and the last two (FB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P24FB mean?
Exhaust air purge valve control circuit high. The control module found that the control circuit of the air purge valve is at a higher voltage than expected, typically from a wire shorted to the supply or from an open circuit. The valve isn't being driven correctly. Only a few manufacturers use this system, and I don't have reliable details on every make.
Can I keep driving with code P24FB active?
With caution: limp mode possible, have it checked soon
Common causes — P24FB
Control wire shorted to the supply voltage Open circuit from a broken wire Loose or corroded connector Solenoid with an open coil Driver fault inside the control module
How do you fix code P24FB?
Have the valve's connector and wiring checked and the coil resistance measured. Then check that the wire isn't touching other live wires. It's wise to act reasonably soon, because filter regeneration can stay compromised.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P24FA — Exhaust air purge valve control circuit low
- Next code: P24FC — Particulate matter sensor heater drawing too much...
Related codes
- P2400 — EVAP leak detection pump control circuit open
- P2401 — EVAP leak detection pump control circuit low
- P2402 — EVAP leak detection pump control circuit high
- P2403 — EVAP leak detection pump sense circuit open
- P2404 — EVAP leak detection pump sense circuit range/performance
- P2405 — EVAP leak detection pump sense circuit low
- P2406 — EVAP leak detection pump sense circuit high
- P2407 — EVAP leak detection pump sense circuit intermittent
- P2408 — Fuel cap sensor/switch circuit
- P2409 — Fuel cap sensor/switch circuit range/performance
- P240A — Engine speed implausible
- P240B — Engine speed received via CAN bus implausible