P2589 — Turbo boost control position sensor B circuit voltage too high
| Meaning | The control unit is reading a higher than normal voltage on the circuit of position sensor B of the turbo control. This usually points to a broken wire, an unplugged connector or contact with a power supply. Turbo pressure cannot be regulated accurately. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Turbo pushing little or unevenly
Engine in limp mode
Weak throttle response
Common causes
Terminals corroded or burned
Position sensor failed
Wire in contact with a power supply
Control unit fault (rare)
What to do
How to read code P2589
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2589 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (89) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2589 mean?
Turbo boost control position sensor B circuit voltage too high. The control unit is reading a higher than normal voltage on the circuit of position sensor B of the turbo control. This usually points to a broken wire, an unplugged connector or contact with a power supply. Turbo pressure cannot be regulated accurately.
Can I keep driving with code P2589 active?
With caution: limp mode possible, have it checked soon
Common causes — P2589
Sensor wire broken or connector unplugged Terminals corroded or burned Position sensor failed Wire in contact with a power supply Control unit fault (rare)
How do you fix code P2589?
Check that the connector is firmly seated and the wires are not broken. With reduced power, drive gently and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2588 — Turbo boost control position sensor B circuit volt...
- Next code: P258A — Vacuum pump A control circuit open
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault