P258A — Vacuum pump A control circuit open
| Meaning | The control unit found that the circuit controlling vacuum pump A is open. The vacuum pump provides suction, for example for the brake booster, on engines that do not make enough on their own. Without the command the pump may not run. |
| Family | Powertrain (P) |
Typical symptoms
Brake pedal harder than normal
Braking that needs more effort
Noise or lack of noise from the pump
Other vacuum-operated functions not working well
Common causes
Control wire broken
Electric vacuum pump failed
Fuse or relay defective
Control unit fault (rare)
What to do
How to read code P258A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P258A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (5) points to vehicle speed, idle control and auxiliary inputs, and the last two (8A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P258A mean?
Vacuum pump A control circuit open. The control unit found that the circuit controlling vacuum pump A is open. The vacuum pump provides suction, for example for the brake booster, on engines that do not make enough on their own. Without the command the pump may not run.
Can I keep driving with code P258A active?
With caution: limp mode possible, have it checked soon
Common causes — P258A
Pump connector unplugged or corroded Control wire broken Electric vacuum pump failed Fuse or relay defective Control unit fault (rare)
How do you fix code P258A?
Check the pump fuse, relay and connector. If the brake pedal feels harder, braking is less assisted: this is not a fault to put off, have it checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2589 — Turbo boost control position sensor B circuit volt...
- Next code: P258B — Vacuum pump A control circuit range/performance
Related codes
- P2500 — Generator lamp / L-terminal circuit low
- P2501 — Generator lamp / L-terminal circuit high
- P2502 — Charging system voltage out of range
- P2503 — Charging system voltage too low
- P2504 — Charging system voltage too high
- P2505 — Engine control unit power input signal fault
- P2506 — Control unit power input signal out of range
- P2507 — Control unit power input signal too low
- P2508 — Control unit power input signal too high
- P2509 — Control unit power input signal intermittent
- P250A — Engine oil level sensor circuit fault
- P250B — Engine oil level sensor range/performance fault