P264B — Rocker arm actuator A position sensor range/performance, bank 1
| Meaning | The position sensor of rocker arm actuator A is sending a signal the computer judges inconsistent with what was commanded or outside the expected values. The electrical circuit may be fine, but the position it reads does not add up. It can come from the sensor itself or from an actuator that moves poorly. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Uneven acceleration
Unstable idle in some cases
Valve system operation limited
Common causes
Faulty or out-of-range position sensor
Sensor or actuator not fitted correctly
Deposits or mechanical wear in the system
Electrical connections with abnormal resistance
What to do
How to read code P264B
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P264B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (4B) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P264B mean?
Rocker arm actuator A position sensor range/performance, bank 1. The position sensor of rocker arm actuator A is sending a signal the computer judges inconsistent with what was commanded or outside the expected values. The electrical circuit may be fine, but the position it reads does not add up. It can come from the sensor itself or from an actuator that moves poorly.
Can I keep driving with code P264B active?
With caution: limp mode possible, have it checked soon
Common causes — P264B
Actuator not moving properly because of poor oil or low pressure Faulty or out-of-range position sensor Sensor or actuator not fitted correctly Deposits or mechanical wear in the system Electrical connections with abnormal resistance
How do you fix code P264B?
First check the oil level and quality, then have the sensor and actuator checked with a diagnostic tool. Avoid keeping the engine under heavy load until the cause is clear.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P264A — Rocker arm actuator A position sensor circuit, ban...
- Next code: P264C — Rocker arm actuator A position sensor circuit low,...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low