P2674 — Injection pump fuel calibration not learned
| Meaning | The control unit has not yet stored the calibration values that set how much fuel the injection pump delivers. It usually happens after the pump or control unit has been replaced, or after the memory was reset. The procedure to learn them varies by brand. |
| Family | Powertrain (P) |
Typical symptoms
Low engine power
Smoke from the exhaust
Rough idle
Jerky running under acceleration
Fuel use that seems different from usual
Common causes
Control unit memory reset
Calibration procedure not done or interrupted
Pump calibration data not entered
Communication error between pump and control unit
What to do
How to read code P2674
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P2674 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (74) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P2674 mean?
Injection pump fuel calibration not learned. The control unit has not yet stored the calibration values that set how much fuel the injection pump delivers. It usually happens after the pump or control unit has been replaced, or after the memory was reset. The procedure to learn them varies by brand.
Can I keep driving with code P2674 active?
With caution: limp mode possible, have it checked soon
Common causes — P2674
Pump or control unit recently replaced Control unit memory reset Calibration procedure not done or interrupted Pump calibration data not entered Communication error between pump and control unit
How do you fix code P2674?
Have the learning procedure carried out with a diagnostic tool compatible with your car, entering the pump calibration data if required. If the car is in reduced power or smokes heavily, limit its use. Otherwise it can be used for short trips until it is repaired.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2673 — Injection pump timing calibration not learned
- Next code: P2675 — Air cleaner inlet control circuit open
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low