P267A — Rocker arm actuator position sensor B circuit, bank 2
| Meaning | The control unit detected a general problem in the circuit of rocker arm actuator position sensor B on bank 2. It cannot reliably read the actuator position. The exact meaning and the component involved depend on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Engine less responsive
Fuel use that seems higher
Possible limp mode
Common causes
Damaged wiring
Faulty position sensor
Sensor supply or ground problem
Rocker arm actuator with a mechanical problem
Faulty control unit (rare)
What to do
How to read code P267A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P267A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (7A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P267A mean?
Rocker arm actuator position sensor B circuit, bank 2. The control unit detected a general problem in the circuit of rocker arm actuator position sensor B on bank 2. It cannot reliably read the actuator position. The exact meaning and the component involved depend on the manufacturer.
Can I keep driving with code P267A active?
With caution: limp mode possible, have it checked soon
Common causes — P267A
Sensor connector corroded or loose Damaged wiring Faulty position sensor Sensor supply or ground problem Rocker arm actuator with a mechanical problem Faulty control unit (rare)
How do you fix code P267A?
Check the connector and wiring of the sensor on bank 2. Then a workshop with diagnostics is needed to read the signal and tell the sensor, wiring and actuator apart. You can use the car for short trips, but it is best to act soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P2679 — Coolant degassing valve control circuit low
- Next code: P267B — Rocker arm actuator position sensor B circuit rang...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low