Skip to content
Fault code dictionary (DTC)

P267B — Rocker arm actuator position sensor B circuit range/performance, bank 2

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the signal from rocker arm actuator position sensor B on bank 2 does not match what it expects. The sensor responds, but the values do not correspond to the command given. It can come from the sensor or from a mechanical problem. The precise meaning depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power
Unstable idle
Slow throttle response
Fuel use that seems higher
Possible limp mode

Common causes

Rocker arm actuator stuck or worn
Position sensor out of calibration or faulty
Dirty, low or wrong-viscosity engine oil
Wiring or connector with abnormal resistance
Insufficient oil pressure
Mechanical problem in the valve train

What to do

Check the engine oil level and condition, because these systems are often oil-operated. If the oil is fine, a workshop diagnosis is needed to verify the actual movement of the actuator. Do not keep driving for long with the light on and reduced power.

How to read code P267B

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P267B starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (7B) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P267B mean?

Rocker arm actuator position sensor B circuit range/performance, bank 2. The control unit detected that the signal from rocker arm actuator position sensor B on bank 2 does not match what it expects. The sensor responds, but the values do not correspond to the command given. It can come from the sensor or from a mechanical problem. The precise meaning depends on the manufacturer.

Can I keep driving with code P267B active?

With caution: limp mode possible, have it checked soon

Common causes — P267B

Rocker arm actuator stuck or worn Position sensor out of calibration or faulty Dirty, low or wrong-viscosity engine oil Wiring or connector with abnormal resistance Insufficient oil pressure Mechanical problem in the valve train

How do you fix code P267B?

Check the engine oil level and condition, because these systems are often oil-operated. If the oil is fine, a workshop diagnosis is needed to verify the actual movement of the actuator. Do not keep driving for long with the light on and reduced power.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes