P267C — Rocker arm actuator position sensor B circuit low, bank 2
| Meaning | The control unit detected that the signal from rocker arm actuator position sensor B on bank 2 has too low a voltage. It usually points to a wire shorted to ground, a break or a faulty sensor. The exact meaning depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Engine less responsive
Fuel use that seems higher
Possible limp mode
Common causes
Sensor supply wire broken
Connector corroded or with loose contacts
Faulty position sensor
Wiring chafed or pinched
Faulty control unit (rare)
What to do
How to read code P267C
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P267C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (7C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P267C mean?
Rocker arm actuator position sensor B circuit low, bank 2. The control unit detected that the signal from rocker arm actuator position sensor B on bank 2 has too low a voltage. It usually points to a wire shorted to ground, a break or a faulty sensor. The exact meaning depends on the manufacturer.
Can I keep driving with code P267C active?
With caution: limp mode possible, have it checked soon
Common causes — P267C
Signal wire touching ground Sensor supply wire broken Connector corroded or with loose contacts Faulty position sensor Wiring chafed or pinched Faulty control unit (rare)
How do you fix code P267C?
Check the connector and wiring of the sensor on bank 2, looking for moisture, corrosion and damaged wires. If the wiring is fine, the signal needs to be measured at a workshop. It is best to act soon, even though the car can often be used for short trips.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P267B — Rocker arm actuator position sensor B circuit rang...
- Next code: P267D — Rocker arm actuator position sensor B circuit high...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low