P267D — Rocker arm actuator position sensor B circuit high, bank 2
| Meaning | The control unit detected that the signal from rocker arm actuator position sensor B on bank 2 has too high a voltage. It usually points to contact with a supply voltage, a broken ground or a faulty sensor. The exact meaning depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Rough idle
Engine less responsive
Fuel use that seems higher
Possible limp mode
Common causes
Sensor ground broken
Connector corroded or loose
Faulty position sensor
Damaged wiring
Faulty control unit (rare)
What to do
How to read code P267D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P267D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (7D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P267D mean?
Rocker arm actuator position sensor B circuit high, bank 2. The control unit detected that the signal from rocker arm actuator position sensor B on bank 2 has too high a voltage. It usually points to contact with a supply voltage, a broken ground or a faulty sensor. The exact meaning depends on the manufacturer.
Can I keep driving with code P267D active?
With caution: limp mode possible, have it checked soon
Common causes — P267D
Signal wire touching a supply voltage Sensor ground broken Connector corroded or loose Faulty position sensor Damaged wiring Faulty control unit (rare)
How do you fix code P267D?
Check the connector and wiring of the sensor on bank 2, especially the ground wire. If all is well, the signal needs to be measured at a workshop. Act soon to avoid incorrect valve timing or lift behavior.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P267C — Rocker arm actuator position sensor B circuit low,...
- Next code: P267E — Rocker arm actuator position sensor B circuit inte...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low