P267E — Rocker arm actuator position sensor B circuit intermittent, bank 2
| Meaning | The control unit is receiving a signal from rocker arm actuator position sensor B on bank 2 that drops in and out or jumps erratically. At times it loses the position information. It is often an electrical contact problem. The exact meaning depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Idle that is unstable at times
Sudden power drops
Unevenness when accelerating
Problems that show up with vibration or rain
Common causes
Wiring with a partly broken wire
Sensor working intermittently
Moisture or dirt in the connector
Unstable sensor supply or ground
Rocker arm actuator with play or wear
What to do
How to read code P267E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P267E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (6) points to computer and output circuits, and the last two (7E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P267E mean?
Rocker arm actuator position sensor B circuit intermittent, bank 2. The control unit is receiving a signal from rocker arm actuator position sensor B on bank 2 that drops in and out or jumps erratically. At times it loses the position information. It is often an electrical contact problem. The exact meaning depends on the manufacturer.
Can I keep driving with code P267E active?
With caution: limp mode possible, have it checked soon
Common causes — P267E
Connector with loose or corroded contacts Wiring with a partly broken wire Sensor working intermittently Moisture or dirt in the connector Unstable sensor supply or ground Rocker arm actuator with play or wear
How do you fix code P267E?
Check the connector and wiring on bank 2, gently moving the wires to see whether the fault shows up. A workshop with diagnostics is then needed to watch the signal live. It is not an emergency, but should not be ignored.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P267D — Rocker arm actuator position sensor B circuit high...
- Next code: P267F — Control module internal temperature sensor A circu...
Related codes
- P2600 — Coolant pump control circuit: open
- P2601 — Coolant pump control circuit: out of range
- P2602 — Coolant pump control circuit: low
- P2603 — Coolant pump control circuit: high
- P2604 — Intake air heater A circuit: range/performance
- P2605 — Intake air heater A circuit: open
- P2606 — Intake air heater B circuit: range/performance
- P2607 — Intake air heater B circuit: low
- P2608 — Intake air heater B circuit: high
- P2609 — Intake air heater system performance
- P260A — PTO control circuit open
- P260B — PTO control circuit low