U043E — Invalid data from vacuum sensor A
| Meaning | The control unit received invalid data from vacuum sensor A, which measures air vacuum, for example the vacuum used by the brake booster. The sensor or its module is communicating, but the values are not believable. What sensor "A" is used for exactly depends on the manufacturer and the type of engine. |
| Family | Network (U) |
Typical symptoms
Brake pedal harder than usual
Braking needing more force
Uneven idle
Reduced power
Error messages on the dashboard
Common causes
Failed vacuum sensor
Cracked or disconnected vacuum hose
Weak or failed vacuum pump
Low or unstable supply voltage
Internal fault in the module receiving the signal
What to do
How to read code U043E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code U043E starts with U: it belongs to the network and communication between control units area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code U043E mean?
Invalid data from vacuum sensor A. The control unit received invalid data from vacuum sensor A, which measures air vacuum, for example the vacuum used by the brake booster. The sensor or its module is communicating, but the values are not believable. What sensor "A" is used for exactly depends on the manufacturer and the type of engine.
Can I keep driving with code U043E active?
With caution: limp mode possible, have it checked soon
Common causes — U043E
Faulty sensor connector or wiring Failed vacuum sensor Cracked or disconnected vacuum hose Weak or failed vacuum pump Low or unstable supply voltage Internal fault in the module receiving the signal
How do you fix code U043E?
Check the sensor connector and the vacuum hoses, then read the other codes. If the brake pedal is unusually hard, it is a safety issue: do not keep driving normally and have the car checked right away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: U043D — Invalid data from accelerator pedal module
- Next code: U043F — Invalid Data Received From Suspension Control Modu...
Related codes
- U0400 — Invalid Data Received from Network
- U0401 — Invalid Data Received From Engine Control Module
- U0402 — Invalid Data Received From Transmission Control Module
- U0403 — U0403 – Invalid data from transfer case control module
- U0404 — U0404 – Invalid data from gear shift control module
- U0405 — U0405 – Invalid data from cruise control module
- U0406 — U0406 – Invalid data from fuel injector control module
- U0407 — U0407 – Invalid data from glow plug control module
- U0408 — U0408 – Invalid data from throttle actuator control module
- U0409 — U0409 – Invalid data from alternative fuel control module
- U040A — U040A – Invalid data from air conditioning control module
- U040B — U040B – Invalid data from EGR control module A