Skip to content
Fault code dictionary (DTC)

B1424 — Rear right window motor circuit shorted to battery

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module detected battery voltage on the rear right window motor circuit where there should not be any. This code is defined by the manufacturer and the detection criteria vary with the brand. It can indicate a wire touching a live wire.
FamilyBody (B)

Typical symptoms

The rear right window does not respond to the controls
The window moves by itself or does not stop
The motor gets hot
The fuse blows
The switch behaves abnormally

Common causes

Damaged insulation causing contact between wires in the door
Motor with an internal fault
Wet or dirty connector
Switch with stuck contacts
Faulty output in the control module

What to do

If the window moves by itself or the motor gets hot, unplug the motor connector or remove the fuse. Then check the wire boot in the door. It is best to act soon to avoid overheating.

How to read code B1424

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1424 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1424 mean?

Rear right window motor circuit shorted to battery. The control module detected battery voltage on the rear right window motor circuit where there should not be any. This code is defined by the manufacturer and the detection criteria vary with the brand. It can indicate a wire touching a live wire.

Can I keep driving with code B1424 active?

With caution: limp mode possible, have it checked soon

Common causes — B1424

Damaged insulation causing contact between wires in the door Motor with an internal fault Wet or dirty connector Switch with stuck contacts Faulty output in the control module

How do you fix code B1424?

If the window moves by itself or the motor gets hot, unplug the motor connector or remove the fuse. Then check the wire boot in the door. It is best to act soon to avoid overheating.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes