Skip to content
Fault code dictionary (DTC)

B1458 — Washer pump relay circuit failure

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningCode B1458 is manufacturer-defined and I have no reliable information on how each brand uses it. The reference definition points to a general failure in the washer pump relay circuit. The control module detected that the relay or its circuit is not behaving as expected.
FamilyBody (B)

Typical symptoms

Washer does not spray
Pump stays on longer than it should
Intermittent spray
Wipers not coordinating with the washer

Common causes

Faulty pump relay
Blown washer fuse
Corroded or broken relay connector or wire
Failing washer pump overloading the circuit
Internal fault in the body control module

What to do

Check the washer fuse and listen for the pump when you operate the control. A dead washer is not an immediate danger, but visibility drops with a dirty windscreen. Have the relay and wiring checked fairly soon.

How to read code B1458

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1458 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1458 mean?

Washer pump relay circuit failure. Code B1458 is manufacturer-defined and I have no reliable information on how each brand uses it. The reference definition points to a general failure in the washer pump relay circuit. The control module detected that the relay or its circuit is not behaving as expected.

Can I keep driving with code B1458 active?

With caution: limp mode possible, have it checked soon

Common causes — B1458

Faulty pump relay Blown washer fuse Corroded or broken relay connector or wire Failing washer pump overloading the circuit Internal fault in the body control module

How do you fix code B1458?

Check the washer fuse and listen for the pump when you operate the control. A dead washer is not an immediate danger, but visibility drops with a dirty windscreen. Have the relay and wiring checked fairly soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes