Skip to content
Fault code dictionary (DTC)

B1461 — Washer pump relay coil circuit short to ground

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningCode B1461 is manufacturer-defined and I have no reliable information on how each brand uses it. The reference definition points to a short to ground on the washer pump relay coil. The module cannot raise the circuit to the voltage needed to operate the relay.
FamilyBody (B)

Typical symptoms

Washer does not spray
No click from the relay
Fuse or module output driver being damaged
Wipers normal

Common causes

Relay control wire pinched against the bodywork
Shorted relay coil
Wet or corroded connector
Wiring chafed where it passes to the door or bonnet
Internal fault in the body control module

What to do

Inspect the wiring where it runs near sheet metal and check the relay. It is not an immediate risk, but the fault can damage the module output, so do not leave it too long.

How to read code B1461

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1461 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1461 mean?

Washer pump relay coil circuit short to ground. Code B1461 is manufacturer-defined and I have no reliable information on how each brand uses it. The reference definition points to a short to ground on the washer pump relay coil. The module cannot raise the circuit to the voltage needed to operate the relay.

Can I keep driving with code B1461 active?

With caution: limp mode possible, have it checked soon

Common causes — B1461

Relay control wire pinched against the bodywork Shorted relay coil Wet or corroded connector Wiring chafed where it passes to the door or bonnet Internal fault in the body control module

How do you fix code B1461?

Inspect the wiring where it runs near sheet metal and check the relay. It is not an immediate risk, but the fault can damage the module output, so do not leave it too long.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes