Skip to content
Fault code dictionary (DTC)

B1507 — Flash-to-pass switch circuit failure

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control module has detected a general fault in the circuit of the switch used to flash the high beams as an overtaking signal. This code is manufacturer-defined and the detail can vary by model. The switch may not respond or may send wrong signals to the module.
FamilyBody (B)

Typical symptoms

High beam flash does not work
High beams flash or come on by themselves
The switch works intermittently
Other controls on the same stalk behaving oddly
Lighting warning light or message on the dashboard

Common causes

Worn or dirty steering column stalk or switch
Switch connector with poor contact
Damaged wiring behind the steering wheel
Worn clockspring (rotating contact) in the steering wheel
Faulty body control module (rare)

What to do

Try the switch several times and check whether the other controls on the same stalk work, since this helps tell a stalk problem from a wiring problem. It does not stop you driving, but have it checked soon if you rely on the overtaking signal.

How to read code B1507

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code B1507 starts with B: it belongs to the body (airbags, comfort, lights) area. It is defined by the manufacturer, so the exact meaning can change from make to make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code B1507 mean?

Flash-to-pass switch circuit failure. The control module has detected a general fault in the circuit of the switch used to flash the high beams as an overtaking signal. This code is manufacturer-defined and the detail can vary by model. The switch may not respond or may send wrong signals to the module.

Can I keep driving with code B1507 active?

With caution: limp mode possible, have it checked soon

Common causes — B1507

Worn or dirty steering column stalk or switch Switch connector with poor contact Damaged wiring behind the steering wheel Worn clockspring (rotating contact) in the steering wheel Faulty body control module (rare)

How do you fix code B1507?

Try the switch several times and check whether the other controls on the same stalk work, since this helps tell a stalk problem from a wiring problem. It does not stop you driving, but have it checked soon if you rely on the overtaking signal.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes